Replacement Print Head PCB for OrangeStorm Giga

ELEGOO Hotend Adapter PCB is an original replacement interconnect board designed exclusively for the large-format ELEGOO OrangeStorm Giga (TL4982) 3D printer. It is located in the print head and consolidates the electrical connections of the individual hotend components.

The board is a suitable solution when the original electronics, connector, or control of the heating element, temperature sensor, or fans is damaged or malfunctioning. It allows you to replace only the defective part instead of the entire print head.

Exact Compatibility

The PCB is dimensionally and connector-compatible with the OrangeStorm Giga printer. It uses the existing print head connectors, so there is no need to modify the wiring or printer structure.

When to Replace the Board

Replacement can be especially helpful in the event of:

• multiple print head functions failing simultaneously,
• heating or temperature sensing errors,
• non-functional hotend fans,
• damaged connectors or printed circuit boards,
• consequences of a short circuit or mechanical damage to the electronics.

Before ordering, we recommend checking the condition of the wiring and the proper seating of all connectors. Similar problems can also be caused by a broken wire or a loose connector.

Easy Service Replacement

The board connects via the print head connectors. Installation requires removing the print head cover and carefully reconnecting the cables. Before disconnecting the original part, we recommend photographing the position and orientation of the individual connectors.

Warning: This is a replacement service part, not a performance upgrade. Compatibility is intended exclusively for the ELEGOO OrangeStorm Giga.

Key Features:

• Original ELEGOO replacement part
• Designed exclusively for the OrangeStorm Giga 3D printer
• Consolidates the electrical connections of print head components
• Direct replacement for a damaged hotend interconnect board
• Compatible with the printer's original wiring and connectors
• Allows repair of the print head electronics without replacing the complete assembly
• Low weight that does not increase the moving mass of the print head