Product Description

Bambu Lab Nozzle Eddy Sensor Right – X2D (FAC206) is an original replacement eddy current sensor located between the right hotend and extruder of the Bambu Lab X2D printer. This sensor is used for active filament flow calibration and for detecting situations where the nozzle is wrapped in molten filament.

Thanks to this, the printer can more accurately control extrusion, improve print quality, and timely recognize potential problems with clogging or material buildup around the nozzle. This is an original Bambu Lab part, designed specifically for the X2D, which guarantees full compatibility and reliable operation.

Key Features

• Original Bambu Lab spare part for model X2D (right sensor – Right)
• Eddy current sensor for monitoring nozzle status and filament flow
• Located between the right hotend and extruder
• Support for active filament flow calibration and detection of nozzle wrapping in molten plastic
• Helps prevent problems with a clogged nozzle and degraded first layer quality
• Compact and lightweight design
• Simple replacement according to the guide in Bambu Lab Wiki
• Full compatibility with Bambu Lab X2D (right/nozzle right)

Usage and Benefits

• Quick repair of eddy current sensor errors – if the printer reports an error related to the sensor at the right nozzle, replacing this part often solves the problem.
• Maintaining high print quality – a properly functioning sensor helps the printer accurately calibrate flow and ensures consistent results.
• Prevention of printer damage – timely detection of a wrapped nozzle reduces the risk of "blob of death" and other emergency states.
• Ideal spare part for stock – for operations that do not want to rely on part availability in case of failure and want to minimize downtime.

Compatibility

• Bambu Lab X2D – right nozzle eddy sensor (Right – X2D)

Note: This is not a universal sensor. It is intended specifically for the right nozzle on the Bambu Lab X2D model. For other models or the left side, the corresponding sensor variant must be used.

Package Contents

• 1× Bambu Lab Nozzle Eddy Sensor – Right (X2D)
• Mounting screws as per manufacturer specification (typically BT2-5 and M2-5) – may vary by specific package revision

Technical Parameters

Installation

The installation of the sensor is relatively simple and can be handled by most users with basic 3D printer service experience:

1. Turn off and disconnect the Bambu Lab X2D printer from the power supply.
2. Access the area around the right hotend and extruder.
3. Remove the original eddy sensor and screws.
4. Install the new Nozzle Eddy Sensor Right – X2D (FAC206) in the same place.
5. Check for correct connector plug-in and cable routing.
6. After turning on the printer, run the recommended calibrations in the Bambu Lab system.

For detailed procedures, always follow the official instructions in the Bambu Lab documentation.

Who is the product suitable for

• Owners of the Bambu Lab X2D printer who are resolving errors related to the right nozzle eddy sensor.
• Users who want to have critical spare parts in stock to minimize downtime.
• Service centers and companies operating multiple Bambu Lab X2D printers in a production environment.

Key Features:

• Original Bambu Lab Nozzle Eddy Sensor Right for model X2D
• Eddy current sensor between the right hotend and extruder
• Supports active filament flow calibration
• Detection of nozzle wrapping in molten filament and prevention of clogging
• Full compatibility with Bambu Lab X2D printer – right nozzle
• Compact, lightweight, and precise electronic component
• Ideal spare part for quick repair and minimization of downtime
• Simple installation according to official Bambu Lab instructions