What it is and what it is used for

An alternative FPC cable that connects the filament Hall sensor and the filament cutter lever in the toolhead to the corresponding board (toolhead/TH). Proper functioning of this cable is necessary for detecting filament presence and the state of the cutter lever; a damaged or improperly inserted cable often causes error messages and print interruptions.

Compatibility

• Bambu Lab P1 Series: P1P, P1S (direct cable replacement for the filament/Hall sensor in the toolhead).
• Variant without printed circuit board (PCB), cable only.

When to replace the cable – typical symptoms

• "Cutter stuck" error or difficulties with retracting/unloading filament even when nothing is mechanically blocked.
• The printer incorrectly reports filament presence (green indication) even without filament, or conversely, does not register filament.
• HMS messages related to the filament/cutter sensor (e.g., codes listed in manuals and discussions). In many cases, replacing or correctly inserting the FPC cable helps.

Installation and tips

• Always unplug the printer power, then carefully release the connector locking tabs and insert the cable straight to the stop.
• Pay attention to alignment – this connector can accidentally be "clicked" shifted by a few tenths of a mm, causing intermittent errors. Once the cable is seated, lightly check the position of the edge relative to the reference "frame" above the connector.
• After replacement, perform a filament load/unload test and a short print to verify sensor function. If problems persist, also check the filament sensor itself and the toolhead/TH board.

Why choose this cable

• Direct replacement for the frequently damaged flat cable at the filament/cutter sensor in the P1 series.
• Quick and affordable repair – in practice, it has solved sensor error states many times and restored automatic filament retraction/cutting.

Package contents

• 1× FPC cable for Hall sensor (filament sensor/cutter), non-original replacement part.

Note: This cable is not an official Bambu Lab accessory. It functionally replaces the original FPC wiring to the Hall sensor in the P1P/P1S toolhead; the wiring principle of hall sensors and their connection to the toolhead board is documented by the manufacturer for similar assemblies.

Key features:

• Direct replacement for a damaged filament/Hall sensor cable in P1P/P1S.
• Helps eliminate "cutter stuck" errors and faulty filament detection.
• Precise connectors for reliable contact in the small toolhead space.
• Easy self-assembly; just correctly insert and secure the connectors.
• Compatible with official P1 series toolhead/TH boards.