ELEGOO OrangeStorm Giga Heated Bed Plate Assembly

Complete heated bed for OrangeStorm Giga

The ELEGOO OrangeStorm Giga Heated Bed Plate Assembly #2 is a complete replacement assembly for one of the four independently heated sections of the print surface of the ELEGOO OrangeStorm Giga printer. Version #2 uses specific power cable lengths, so it is important to verify the original part designation before ordering.

The assembly is supplied pre-assembled and includes a PEI print plate, magnetic bed, heating element, thermal insulation, and thermistor. It is a practical solution in the event of damage to the print surface, a heating fault, or inaccurate temperature measurement.

Assembly contents

• 1× PEI print plate
• 1× magnetic layer
• 1× heated bed
• 1× thermal insulation
• 1× thermistor

Why choose the complete assembly

• Direct compatibility with the ELEGOO OrangeStorm Giga
• Supplied as a pre-assembled unit
• PEI surface provides good first-layer adhesion
• Magnetic design makes it easier to remove the print plate
• Integrated thermistor enables bed temperature measurement
• Thermal insulation helps reduce heat loss
• Replaces one independently heated section of the modular print surface

Important note regarding version #2

The OrangeStorm Giga uses four heated bed versions designated #0 to #3. The individual versions differ in cable length. For assembly #2, the approximate length of the red and black power wires is 990 mm, and the length of the white thermistor wire is 850 mm.

Before purchasing, compare the cable designation and lengths with the original part. The versions cannot be selected based on appearance alone. Always perform installation with the printer switched off and disconnected from the mains.

Compatibility

This replacement part is intended exclusively for the ELEGOO OrangeStorm Giga FDM 3D printer (TL4982). One assembly corresponds to one section of the four-part print platform measuring approximately 410 × 410 mm.

Key features:

• Original replacement assembly for ELEGOO OrangeStorm Giga
• Version #2 with specific power wire length
• Complete pre-assembled design
• Includes a PEI print plate and magnetic layer
• Integrated heating element, insulation, and thermistor
• Designed for one of the four independent sections of the print surface
• Maximum heated bed temperature up to 100 °C