Free shipping from €82.00

Original ELEGOO NTC 100K replacement thermistor for the OrangeStorm Giga 3D printer hotend. It ensures precise nozzle temperature measurement, stable heating control, and safe operation at temperatures up to 300 °C.
The ELEGOO Hotend Thermistor NTC 100K is an original replacement temperature sensor designed for the ELEGOO OrangeStorm Giga 3D printer. It continuously measures the temperature of the heater block and sends the measured values to the printer's control electronics. Based on these values, the electronics regulate the hotend heating and maintain the set temperature throughout the print.
A properly functioning thermistor is essential for consistent filament extrusion, stable material flow, and protection of the hotend against overheating. This NTC 100K thermistor supports an operating hotend temperature of up to 300 °C on the OrangeStorm Giga.
The sensor is designed specifically for the print head of the ELEGOO OrangeStorm Giga. The matching wiring and connector enable connection to the TH1 port on the print head adapter board without modifying the firmware or electronics.
Replacement is particularly recommended in the following cases:
Before replacing the thermistor, turn off the printer, disconnect it from the power supply, and allow the hotend to cool completely. Handle the thermistor's fine wires carefully and, after installation, check that the cable is routed correctly and that the measured temperature is stable. The product is intended for the hotend, not as a replacement sensor for the heated bed.
| Manufacturer | ELEGOO |
| Product type | Hotend replacement thermistor |
| Sensor type | NTC 100K |
| Rated resistance | 100 kΩ |
| Purpose | Measuring the hotend heater block temperature |
| Compatibility | ELEGOO OrangeStorm Giga |
| Supported hotend temperature | Up to 300 °C |
| Connection in the print head | TH1 port |
| Catalog designation | 04.208.0019 |
| Package contents | 1× thermistor |
| Approximate weight | 34 g |